KitchenAid spans the range from countertop mixers to serious built-in refrigeration and dishwashers, and its higher-end kitchen appliances are common throughout Boulder and the Front Range. As part of Whirlpool, KitchenAid uses the well-documented F#-E# fault-code system, which makes for fast, accurate diagnosis when each code is confirmed at the component.
Models We Service
- Built-in and counter-depth refrigerators and column units
- Single and double wall ovens and combination ovens
- Induction, gas, and electric cooktops
- Panel-ready and integrated dishwashers
- Ranges in gas, dual-fuel, and electric
Error and Fault Codes
KitchenAid uses the Whirlpool F#-E# format. The families below are the ones we see most across ovens and dishwashers; we confirm each at the part.
| Code | Typical Meaning | What We Do |
|---|---|---|
F1-E0 | Control board fault | Test and replace the control board |
F2-E0 | Stuck key or touch-panel fault | Test panel and control, replace failed part |
F3-E0 | Oven temperature sensor open or shorted | Ohm-test sensor, replace out of range |
| Dishwasher heating code | Heater or thermistor circuit | Test heater and thermistor, replace failed part |
| Refrigerator warm | Fan, defrost, or damper fault | Test fan and defrost, clear ice, replace part |
Common Problems We Fix
On KitchenAid refrigeration, warm compartments trace to the evaporator fan, defrost heater, or a stuck damper, and ice makers fail at the fill valve and module. On the ovens, the temperature sensor and bake element are the usual failures, with stuck-key faults on the touch panels. KitchenAid dishwashers develop drainage clogs and drying complaints, both usually mechanical rather than a control failure. Whirlpool parts are widely available, so most KitchenAid repairs finish quickly once diagnosed.
Maintenance and Guides
See our KitchenAid maintenance guide for refrigeration and dishwasher care, and our high-altitude cooking tips for Boulder kitchens.
Kitchenaid Showing a Code?
Book a KitchenAid diagnosis. Diagnostic and travel fees, if applicable, are confirmed before the appointment and before repair approval.